Los Angeles County · a neighborhood of the City of Los Angeles
Electrician in Hollywood
Licensed electricians for Hollywood, from 1920s bungalow courts and the historic streets off Fairfax to the hillside homes above Franklin Avenue, with free estimates on eligible work.
Small repairs welcome · Free estimates on eligible work · Licensed C-10 #1100231Call (844) 430-7681
What we do in Hollywood
Everything we do in Hollywood, with what each job usually involves here. The photos are from our own jobs.
New main panel, new breakers and clean wiring
Panel upgrades in Hollywood
Meter-bank and house-panel replacements for bungalow courts and 1920s apartment buildings, and service upgrades for houses in the HPOZ streets and the hills, with the meter location settled with LADWP and, in an HPOZ, checked with the planning staff before work is scheduled.
Chargers in the carports and garages of post-war apartment buildings, where tenants can request one under state law, and in hillside garages, with the panel and meter bank checked before anything is promised.
Inside a main panel: breakers, feeders and labeled circuits
Electrical repair & troubleshooting in Hollywood
Breakers that trip when small 1920s units run modern loads, dead outlets on early circuits, and faults in meter banks and house panels that have served a building for decades.
New construction rough-in: panel set and circuits run before drywall
Rewiring in Hollywood
Rewiring 1910s and 20s houses in Spaulding Square, Sunset Square and Whitley Heights, and bungalow-court cottages one at a time, so the rest of the court stays occupied.
Recessed lighting on a vaulted ceiling with a cluster of three woven pendants
Lighting & ceiling fans in Hollywood
Common-area and courtyard lighting for apartment buildings, recessed and fixture lighting for remodels, and outdoor lighting placed with the fire-zone brush clearance in mind on the hills.
LED exit sign wired in surface conduit above a warehouse door
Commercial electrical in Hollywood
Tenant improvements and lighting for streetcar-era storefronts on Hollywood, Sunset and Santa Monica boulevards, and equipment circuits for the commercial and light-industrial buildings around Highland Avenue and Romaine Street.
Also: subpanels, dedicated circuits, 240-volt outlets for dryers and ranges, exterior and security lighting, hard-wired smoke alarms, and small repairs of every kind.
Need an electrician in Hollywood? Call now, or send the form and we'll call you back to set a time for an on-site estimate.
Infinity Electrical Inc. (CSLB #1100231) is a licensed electrical contractor working throughout Hollywood: troubleshooting and repairs, panel and meter-bank upgrades, EV chargers, rewiring, lighting and commercial work. Hollywood is inside the City of Los Angeles, so electrical permits come from LADBS and power comes from LADWP, not Southern California Edison.
Most of Hollywood took shape in the 1920s and 1930s. Bungalow courts went up in colonies a few blocks from the studios, and apartment houses lined the streets that had streetcar lines. After World War II, inexpensive stucco apartment buildings filled the gaps in the flats, while houses climbed the hills along the Cahuenga Pass and canyons like Beachwood, Nichols and Laurel. The film business never left: Paramount still operates on Melrose Avenue, and the blocks around Highland Avenue and Romaine Street grew up with prop houses, costume houses, film labs and equipment vendors.
So a week of calls here can mean a breaker that won't hold in a 1920s court, a charger for a tenant's carport space and new lighting for a storefront on Hollywood Boulevard. We look at the job first, then put the price in writing.
A neighborhood of the City of Los Angeles, Los Angeles County
Areas we cover in Hollywood
Hollywood flats
Spaulding Square
Sunset Square
Whitley Heights
Hollywood Boulevard corridor
Media district near Highland and Romaine
Good to know
Inside the City of Los Angeles; West Hollywood next door is its own city on SCE power
ZIP 90046 crosses the city line, so check the bill, not the ZIP
HPOZs include Whitley Heights, Spaulding Square, Sunset Square, Hollywood Grove and Melrose Hill (not a complete list)
Portions are in the city's Very High Fire Hazard Severity Zone
4.9★ from 232 Google reviews across our service area · Licensed C-10 #1100231 · Free estimates on eligible work
What's common in Hollywood homes
In Hollywood the electrical work follows the building type more than the street name, and most buildings date from the 1910s to the 1960s.
Bungalow courts from the 1920s. Hollywood still has a substantial number, scattered through the flats, though few are unaltered. Small cottages, often fed from one shared service and meter bank, with original circuits that were never meant for air conditioning or a modern kitchen. Dedicated circuits, cottage-by-cottage rewiring and meter-bank replacements are the usual jobs.
1920s apartment houses and apartment hotels. Buildings of four stories or more in the foothills north of Hollywood Boulevard, and apartment houses on the old streetcar streets. House panels for corridors, laundry and common lighting, and unit panels with little spare capacity.
Post-war stucco apartments. Infill buildings from the 1950s and 60s, including dingbats like those on Hayworth Avenue, with parking under or beside the building. That's where tenants ask for chargers, and where the meter bank decides what's possible.
Historic houses. Modest one-story Period Revival houses in Spaulding Square (1916–1926), Craftsman and Spanish Colonial Revival houses in Sunset Square, mostly from the 1910s and 20s, and Whitley Heights' Spanish Colonial Revival houses (1918–1928) on hilly lots. Early wiring and small services, upgraded with the exterior rules in mind.
Hillside homes. Houses along Beachwood Drive, Outpost Drive and the canyon roads, some on steep lots, with additions, outdoor lighting and equipment added over the decades.
Permits and power in Hollywood
Hollywood (ZIP codes 90028, 90038, 90068, parts of 90027 and 90046) is City of Los Angeles, but on its west side is the City of West Hollywood, which has its own Building and Safety Division and is served by Southern California Edison. ZIP 90046 covers addresses on both sides of that line, so the ZIP code alone doesn't tell you whose rules apply. We confirm it from the exact address or the utility bill before the estimate.
Several Historic Preservation Overlay Zones (HPOZs) lie in the Hollywood community plan area, among them Whitley Heights in the hills north of Franklin Avenue, Spaulding Square off Sunset Boulevard, Sunset Square (between Hollywood and Sunset boulevards, from Fairfax Avenue to Vista Street), Hollywood Grove in the foothills, and Melrose Hill on the East Hollywood side. These are examples, not a complete list, so we check the parcel's zoning before the estimate. City Planning's rule of thumb is that all exterior alterations in an HPOZ need its approval. A relocated meter, a new exterior panel, conduit on a street-facing wall or new outdoor fixtures are exterior changes, so we raise them at the estimate and check with the HPOZ staff before the work is scheduled.
The Fire Department lists Hollywood among the communities with portions in the city's Very High Fire Hazard Severity Zone, and the city's Fire Zone Map shows whether a given lot is in it. On those lots brush clearance can extend up to 200 feet from structures, which is worth keeping in mind when we plan landscape lighting and other outdoor equipment.
Permits come from the Los Angeles Department of Building and Safety (LADBS). A new circuit, an EV charger, a sub-panel or a panel replacement is permitted work, and LADBS will not send an inspector until the permit is issued. We pull it under our license and meet the inspector at the end.
Power comes from the Los Angeles Department of Water and Power (LADWP), not Southern California Edison. For repairs, lighting, new outlets and a charger that fits on the existing panel, LADWP is not involved. For a panel or service upgrade it is: the job starts with LADWP's free meter spot, where an Electric Service Representative visits within five to fifteen business days, confirms where the new equipment may go and leaves a sketch at the job (single-family services up to 320 amps can be requested online). When only the meter needs setting, LADWP says that generally happens within ten working days. If the existing LADWP service can carry the new load there are generally no LADWP charges; work in the street, on a transformer or on the lines can add cost and time, and we find that out before you commit.
Hollywood Hills and Hollywood Hills West to the north, and Los Feliz and East Hollywood to the east, are City of Los Angeles neighborhoods on LADBS permits and LADWP power, and so is Studio City over the hills. West Hollywood, on the west, is an independent city with its own Building and Safety Division and Southern California Edison as its utility.
See the full list of areas we cover across Los Angeles, Orange and Ventura counties.
From our jobs
Four-unit meter stack for a multi-family buildingPanel upgrade with a new LADWP meter, labeled circuits and solar disconnect labelingLevel 2 EV charger on an exterior wall, cable wrapped on the unitSeven-globe cluster pendant on a brass canopy with recessed lights
No phone quotes and no guessing. A written estimate after we've seen the job, then permitted, inspected work.
STEP 01
Reach out
Call or send the form. A photo of the panel or the problem helps us come prepared.
STEP 02
On-site visit
We come to your home or business and look at the panel, wiring or site.
STEP 03
Written estimate
Scope, price and timeline in writing before you decide anything.
STEP 04
Permitted, inspected work
We pull the permit, coordinate your utility when needed, and finish with the inspection.
Questions people ask
Is my Hollywood address served by LADWP or Southern California Edison?
If it's inside the City of Los Angeles, LADWP. West Hollywood, next door, is served by Southern California Edison, and ZIP 90046 includes addresses in both cities, so check the name on your electric bill rather than the ZIP. We confirm it before the estimate, because a service upgrade follows a different procedure with each utility.
Our house is in the Spaulding Square HPOZ. Does electrical work need HPOZ approval?
Work that changes the outside of the house can. City Planning's rule of thumb is that all exterior alterations in an HPOZ need its written approval, so moving a meter or panel, running conduit on a visible wall or adding exterior fixtures should be cleared with the HPOZ staff first. New circuits, rewiring inside the walls and interior lighting don't change the exterior, so they don't usually fall under that rule. The same applies in every HPOZ, including Sunset Square, Whitley Heights and Hollywood Grove, and if a project is unclear, the HPOZ staff answer questions by email.
I rent an apartment in Hollywood. Can I get an EV charger at my parking space?
Often, yes. Under California Civil Code section 1947.6, a landlord must approve a tenant's written request to install a charger at the tenant's assigned space, if the tenant follows the landlord's approval process and agrees in writing to the conditions the law sets, which include paying for the installation and the electricity and carrying liability insurance. Exceptions include properties with fewer than five parking spaces, buildings where chargers already serve at least 10 percent of spaces and leases without parking; the rent-control exemption doesn't apply to leases signed, extended or renewed since January 1, 2019. We can assess the panel and the meter bank for you and your landlord.
Is my Hollywood house in the fire zone, and does that change electrical work?
Possibly: portions of Hollywood are in the city's Very High Fire Hazard Severity Zone, and the Fire Department's Fire Zone Map shows whether your lot is. Inside the zone, brush clearance can extend up to 200 feet from structures, so we plan outdoor work such as landscape lighting or a gate or pump circuit with that clearance in mind. Work inside the house is planned the same way as anywhere else in the city.
We own a 1920s bungalow court. Can the meter bank be replaced with tenants in place?
Usually, yes. When the court is fed from one service, the changeover is the step that takes the whole court off power, because LADWP disconnects and reconnects the service, so it is scheduled in advance and tenants get notice. Rewiring the cottages themselves can then go one unit at a time. We look at the meter bank and a couple of units on the site visit and give you the plan and price in writing.
Ready when you are.
Call now, or send the form and we'll call you back to schedule an on-site estimate.